|
NB: When you open the thumbnail you may not be able
to see ALL of the picture in one view and may have to scroll to see
it all. |
|
Y and YT Rear axle half shafts and differential gaskets
PDF file
version
When switching out the half shafts or removing the differential on an MG Y or YT, it
is a good idea to make and fit some new gaskets. The differential gasket is the larger of the two. Click on
thumbnail to open full sized picture to print from onto sheet of gasket
paper. |
|
|
Roof Gutter Layout
If the rear drain tubes from the sun roof on the MG Y
and YB become blocked, water will back up and rot out the rear cross
member of the sun roof assembly. Here is a dimensioned drawing by
Roy Clapham of the roof gutter so that you can fabricate a new one.
|
Headlining cutting pattern
When Roy Clapham recently fitted a headlining to
his car, the one he
purchased from NTG, apart from the main roof piece, he
had to cut the rest as per the drawing
he sent in.
|
|
|
Gear lever gaiter and fuel tank inner wing gasket hold down ring.
PDF file
version
Made from
steel.
|
|
Strengthener
for YT rear passenger compartment
located between outer and inner
panels and behind door check strap.
|
PDF file version
Jackall
pump front plate gasket
Click on
thumbnail to open full sized picture to print from onto sheet of gasket
paper. |
|
YB Body mount
- see
Technical Page for
full details |
Pedal box inspection cover plate
PDF file version
Actual size Material - sheet metal. A rubber gasket can be cut to the same shape and
size from an old inner tube. Simply print out and cut a piece of card to the same
profile, trace around the card onto the metal and then cut the metal. |
|
Cover plate
for brake fluid reservoir access through floorboards.
PDF file version
Made from
steel. |
Radiator Drain Pipe
PDF file version
If you do not wish to make your own, they are available
as a purchase item from either Abingdon Spares LLC in the USA (part number
19-101b and the drain tap is part number 19-101a) or NTG in the UK (part
number B884B, the drain tap is part number B884 and the washer is B884A).
Please see the Links page for contact details of
these vendors. |
|
Gear box
filler and dipstick hole cover.
PDF file version
Often
misplaced or lost on a restoration, you can now remake this part to the
original specifications. |
Original licence plate/number plate bracket for front
licence plates
PDF file version
Two per car, made from 3mm steel.
|
|
Boot
liners for the MG Y, YT and YB
The MG Y Series had millboard liners to line the inside
walls of the trunk. These were made from Millboard. The fold line
can be made by scoring a line about 1/3rd depth to the FRONT side of
each piece. Another piece of Millboard was placed across the rear
of the rear seat panel too: this piece was fitted to the saloons only and
not to the YT, whereas the side panels were common across all models.
|
Boot Floor Liner for the MG Y, YT
and YB
The MG Y Series also had a one-piece panel of black
painted thin bituminous felt type material. The metal and wooden floor panels on all cars were covered by this. It was not stuck down, but could be
removed. |
